Description
The neck screw of your 3D printer provides the optimal heat dissipation from the heating block into the coldend? If your filament often "jams" in the throat, it may be because the processing and heat conduction performance is not optimally matched to your printing process. We have put together feed tubes in different lengths and designs for 1.75mm and 2.85/3.00mm filament for you and our proven quality.
Advanc3D's Premiumthroats are a series of high quality neck screws that will give you a noticeable difference when printing. A high quality feed is like an oiled pipe in the figurative sense - it just flows!
All Advanc3D neck screws are made from the highest quality brass CuZn37, steel X 8 CrNiS 18-9 or titanium Ti-5Al-2.5Sn using the latest technology.
Features:
Material: Brass CuZn37
Filament diameter: 1.75/3.00mm
Length: 20mm
Heel: with heel
Heater block side: M6
Cold end side: M7
Suitability: for PTFE inliner
Advanc3D's Premiumthroats are a series of high quality neck screws that will give you a noticeable difference when printing. A high quality feed is like an oiled pipe in the figurative sense - it just flows!
All Advanc3D neck screws are made from the highest quality brass CuZn37, steel X 8 CrNiS 18-9 or titanium Ti-5Al-2.5Sn using the latest technology.
Features:
Material: Brass CuZn37
Filament diameter: 1.75/3.00mm
Length: 20mm
Heel: with heel
Heater block side: M6
Cold end side: M7
Suitability: for PTFE inliner
Reviews
There are no reviews yet.
