Advanc3D DaVolcano Brass CuZn37 Nozzle in 0.8mm for 3.00mm Filament

The nozzle of your 3D printer is clogged and you can no longer clean it? Just replace the nozzle with one of our new ones. We offer nozzles for 3D printers in different sizes made of stainless steel, brass or titanium.change also the diameter. We have nozzles with a diameter of 0.2mm, 0.3mm, 0.4mm, 0.5mm, 0.6mm and 0.8mm. Of course, depending on the respective nozzle type.

Unlike the other designs, the tip of the nozzle is very close to the heating block, which means that the heat in the filament is kept optimal until the actual printing. This variant of the V6 Nozzle is developed for the so-called DaVolcano heating blocks. Here, the heating cartridge is mounted vertically and the melting zone is thus extended. The long heating zone has the advantage that you can run larger nozzle diameters at higher speeds without having problems with the material feed or a back pressure. These nozzles can ONLY be used with a DaVolcano heating block.



Advanc3D premium nozzles are a series of high quality replacement nozzles that will give you a noticeable difference when printing. A high quality nozzle is like a sharpened pencil - simply indispensable for perfect results!
All Advanc3D nozzles are made of brass CuZn37, steel X 8 CrNiS 18-9 or titanium Ti-5Al-2.5Sn of the highest quality and using the most advanced technology. All nozzles are manufactured with a tolerance below ± 0.01 mm. This results in a very smooth and uniform extrusion, which is of course noticeable in the print quality!
For best results we recommend to re-level your print bed after each nozzle change. Our nozzles are also compatible with other 3D printers, but may have a different height.
Advanc3D nozzles are the perfect choice for enthusiasts who want to get more out of their 3D printer!

Features:
Type : DaVolcano
Material: Brass CuZn37
Diameter of the nozzle: 0.8mm
Filament diameter: 3.00mm
Nozzle type: Direct
Tube length: 21mm
Flare width: 7mm
Lens thread: M6
Tube thread length: 16mm
Suitability for nozzles: Not suitable for abrasive materials
Special feature: Due to the extra long melting zone, you can convey the material faster than with standard hotends. So you can also print faster. Only suitable for Volcano heating blocks.